Here we present servo drives for various kits before moving. From simple turning up to full mobile model.

As a ready water crane with rotary drive (D)

Kleinbekohlung with crane as a finished and the actuator as a set (D)

Crossings with real wire (0.25 mm twisted 49fach) to control the booms in H0. TT. N. planned only as a finished part. To us they would then send a piece of track approximately 15cm. He should fit, yes. Car system (prepared eingearbetet magnetic tape) on request). (D)

Überladekran two movements up / down - left / right as an assembled and tested model
 Car system (prepared magnetic eingearbetet) (A) - (A / D)

Prefabricated with Schwenktor (D)

Carsystem ride on a double garage to the real is still to be (D)

                                D stands for digital servo that is driven by a servo decoder

A stands for analog systems good for show, this is also used for the servo's movement, the end position (not run aground)
and the optimum speed of an adjustable analog servo decoder.
This is controlled with two buttons, with a renewed push a button, the motion stops.

Would you like to be one of your models equipped with a drive, talk to us. Maybe we can find a tailored exactly to your model possible. Bock / indoor crane model, sliding doors swing doors whether in a shed or a car, shed, garage or warehouse doors factory gates
There is much that could move.